One Sub for Bond, Electrical & Gas
Every pool build needs a bond grid, an electrical rough and trim, and — on gas-heated pools — a gas line, and most builders schedule two or three different subs to get there. Perfect Catch carries the pool, electrical, and gas licenses on one team, so every one of those phases comes from one sub, on one schedule, with one point of contact. Fewer trades to coordinate, fewer scheduling gaps between your shell, deck, and equipment-set milestones, and no finger-pointing when an inspector has a question.
Builder Services
Bond Only
- NEC 680 bonding grid installed before deck pour
- Continuity tested
- Ready-for-deck signoff so your pour stays on schedule
Bond & Lights
- Everything in Bond Only
- Light conduits set before the pour
Standard Electrical Install
- GFCI breakers
- Wiring for pump, heater, salt system, automation, and lights
- Sub-panels where the load requires them
- Inspection-ready when we leave
Automation Electrical Install
- Automation system electrical installation, wired to the controlled equipment
Gas Rough-In & Gas Tie-In
- Rough-in: meter-to-pad gas line, properly sized, pressure tested
- Tie-in: valve, drip leg, and fire-up of the heater
Site Visits
- On-site visits to verify phase readiness and keep your build moving
Frequently Asked Questions
What do you need from us to get on the schedule?
The permit number, plans, and phase readiness. Tell us where the build stands — shell in, ready for bond, ready for deck, equipment set — and we schedule the right crew for that phase.
Can you do just the bond?
Yes. Bond Only is a standalone service: NEC 680 bonding grid before deck pour, continuity tested, with a ready-for-deck signoff. Add light conduits with Bond & Lights if the pour needs them set.
Do you handle the gas line too?
Yes — under our own gas license (LI4527). Gas Rough-In runs the meter-to-pad line, sized and pressure tested. Gas Tie-In finishes with the valve, drip leg, and fire-up of the heater. No separate gas sub needed.
Will the work pass inspection?
Inspection-ready at every phase is the standard we work to — bond grids continuity tested before deck pour, electrical installs done to code with GFCI protection, gas lines pressure tested.
What areas do you cover?
We work with pool builders and GCs across Pinellas County and the Tampa area.